1 FastATA Mk4 Installation Part 2 18/9/2012, 20:20
Amiga4000
A Wee Bit Chatty
OK then! I have reinstalled the FastATA Mk4 adapter using the wire wrap sockets which worked perfect! Clipping the pins is a little tricky. There is NO reason to use tie-wraps on the sockets as all pins are very secure on both the top and bottom. I'm very concerned about the socket on top of the GAYLE chip popping off though, expecially with the machine running as it popped off all by itself just sitting there before power-up.
Now back to the problem during the pre-fit.
When I power up, all the hardware is definetely working properly. However, after installing the software during the pre-fit phase, I get this message at bootup:
Requester Box Heading: Software Failure
PSDLOADMODULE
Program Failed (error #80000004)
wait for disk activity to finish
I can boot the machine to a command line from the early startup sequence by bypassing startup files and I can get a directory list.
Not sure why the software installation went sour. Any help appreciated!
Now back to the problem during the pre-fit.
When I power up, all the hardware is definetely working properly. However, after installing the software during the pre-fit phase, I get this message at bootup:
Requester Box Heading: Software Failure
PSDLOADMODULE
Program Failed (error #80000004)
wait for disk activity to finish
I can boot the machine to a command line from the early startup sequence by bypassing startup files and I can get a directory list.
Not sure why the software installation went sour. Any help appreciated!